Stability of steep slopes in cemented sands

The analysis of steep slope and cliff stability in variably cemented sands poses a significant practical challenge as routine analyses tend to underestimate the actually observed stability of existing slopes. The presented research evaluates how the degree of cementation controls the evolution of steep sand slopes and shows that the detailed slope geometry is important in determining the characteristics of the failure mode, which in turn, guide the selection of an appropriate stability analysis method. Detailed slope-profile cross sections derived from terrestrial lidar surveying of otherwise inaccessible cemented sand cliffs are used to investigate failure modes in weakly cemented [unconfined compressive strength (UCS)<30 kPa">(UCS)<30 kPa(UCS)<30 kPa] and moderately cemented (30<UCS<400 kPa)">(30<UCS<400 kPa)(30 sands and their role in the evolution of the geometry of the slopes. The results show that high-resolution slope topography, such as can be obtained with terrestrial lidar, is essential for identifying altogether different failure modes in weakly cemented (shear-mode) and moderately cemented (tensile-mode) sand slopes. Analyses show that the standard Culmann method for steep slopes is inappropriate for modeling the stability of cemented sand slopes since it tends to overpredict expected crest retreat and underestimate failure plane angle. Instead, a simplified analysis using infinite slope assumptions, but applied to a slope with finite dimensions subject to changing geometric conditions, such as toe erosion and slope steepening, is suggested for analysis of weakly cemented sand slopes. For moderately cemented sand slopes, a limit equilibrium analysis directly comparing the cliff tensile stress and cemented sand tensile strength is shown to reasonably predict failure conditions and timing as a result of either slope steepening or tensile strength loss, presumably from wetting in most cases.