Taming a wild geothermal research well in yellowstone national park
In November 1992 the valve at the top of a U.S. Geological Survey drill hole in Yellowstone National Park parted from the casting as a result of corrosion. This allowed uncontrolled venting of boiling water and steam from the well at an estimated liquid flow rate of about 25-50 gallons per minute. A flow diverter assembly was designed, fabricated and installed on the well within 16 days, which allowed drill rods to be safely stripped into the well through on annular Blow-Out Preventer. Once this was accomplished it was a relatively routine matter to set a packer in the casting and cement the well shut permanently. The drill hole was brought under control and cemented shut within 18 days of the wellhead failure at a total cost of $47,066, which was about $5,000 less than anticipated.
Citation Information
Publication Year | 1993 |
---|---|
Title | Taming a wild geothermal research well in yellowstone national park |
Authors | Robert O. Fournier, Larry M. Pisto, Bruce B. Howell, Roderick A. Hutchnson |
Publication Type | Conference Paper |
Publication Subtype | Conference Paper |
Index ID | 70017982 |
Record Source | USGS Publications Warehouse |