Interstitial water studies on small core samples, Deep Sea Drilling Project, Leg 5

Leg 5 samples fall into two categories with respect to interstitial water composition: 1) rapidly deposited terrigenous or appreciably terrigenous deposits, such as in Hole 35 (western Escanaba trough, off Cape Mendocino, California); and, 2) slowly deposited pelagic clays and biogenic muds and oozes. Interstitial waters in the former show modest to slight variations in chloride and sodium, but drastic changes in non-conservative ions such as magnesium and sulfate. The pelagic deposits show only relatively minor changes in both conservative and non-conservative pore fluid constituents. As was pointed out in earlier Leg Reports, it is believed that much of the variation in chloride in pore fluids within individual holes is attributable to the manipulation of samples on board ship and in the laboratory. On the other hand, the scatter in sodium is due in part to analytical error (on the order of 2 to 3 per cent, in terms of a standard deviation), and it probably accounts for most of the discrepancies in total anion and cation balance.

All constituents reported here, with the exception of bulk water content, were analyzed on water samples which were sealed in plastic tubes aboard ship and were subsequently opened and divided into weighed aliquots in the laboratory. Analytical methods follow the atomic absorption, wet chemical and emission spectrochemical techniques briefly summarized in previous reports, e.g. Manheim et al., 1969, and Chan and Manheim, 1970. The authors acknowledge assistance from W. Sunda, D. Kerr, C. Lawson and H. Richards, and thank D. Spencer, P. Brewer and E. Degens for allowing the use of equipment and laboratory facilities.