Interstitial water studies on small core samples, Deep Sea Drilling Project, Leg 6

Sediments from Leg 6 sites, west of the Hawaiian Islands, consisted primarily of various combinations of deep-sea biogenic oozes, volcanic ash, and its breakdown products. Pore fluids from most of the sites were similar in composition to present day ocean water, and in some sties almost identical. However, interstitial fluids from Site 53 (Philippine Sea) showed changes in ionic composition which were beyond those previously considered attributable to diagenetic influence. These samples show the beginnings of metamorphism by dramatic increases in calcium concentrations and corresponding decreases in alkali concentrations.

Analytical methods were similar to those outlined in previous Leg Reports. However, obvious contamination of aliquots for sodium determination in the laboratory made it necessary to determine all sodium values by difference between anion and cation balances. These values are, if anything, more accurate than direct determinations which have been discussed in earlier legs. However, the authors will continue to analyze sodium directly, and in the future they may be able to improve the precision of the determinations to the point where small losses and gains of sodium in the pore fluids may be established accurately.

Agreement between colorimetric and spectrometric determinations of silicon has improved, but there are still occasional marked differences for which the writers have no explanation. T. Takahashi has allowed the authors to compare total Carbon Dioxide (CO₂) measurements from his laboratory with their alkalinity determinations: both sets of data were obtained from fluids from the same squeezings of sediments and should give similar values at the indicated pH levels. Some disturbingly large discrepancies in the two sets of data are evident. The authors do not think that their back-titration alkalinity technique alone is responsible for the differences. However, they have not evaluated the possible influence of the heat-sealed polyethylene pipes on the alkalinity values; this should be considered a potential source of error.

The pH data from water samples processed and measured on shipboard are reported here. In view of the major changes in pressure and temperature (laboratory temperatures were reported to be 26 to 28°C) and the sediments to new gaseous regimes prior to pH measurement, these values should be interpreted mainly as applying to the squeezed effluents, not to in situ values.